Tim's Stuff v02 https://www.murfy.us/ 2026-04-14T12:11:30+00:00 https://www.murfy.us/ https://www.murfy.us/lib/exe/fetch.php?media=wiki:logo.png text/html 2015-01-13T22:06:03+00:00 Anonymous (anonymous@undisclosed.example.com) https://www.murfy.us/doku.php?id=timtechcorvairwiki:06c_rear_axle:check_your_differential_lube&rev=1421186763&do=diff CHECK YOUR DIFFERENTIAL LUBE by Tim Palmer When was the last time you checked your differential lube level? We know of three cases in the last month where the lube level was allowed to low and caused the catastrophic failure of a differential. In the worst case scenario this type of failure could cause a serous accident, under the best case scenario it hurts your pocket book. text/html 2015-01-15T21:23:52+00:00 Anonymous (anonymous@undisclosed.example.com) https://www.murfy.us/doku.php?id=timtechcorvairwiki:06c_rear_axle:early_cars_and_trucks_rear_axle&rev=1421357032&do=diff Early Cars and Trucks Rear Axle(Part of the series: "More than you ever wanted to know") By Tim Palmer and Gary Baxter The purposes of this article are: * To document what we think we know. Much of what is in this is either not in any of the recent books or not in much detail. text/html 2015-01-15T13:47:31+00:00 Anonymous (anonymous@undisclosed.example.com) https://www.murfy.us/doku.php?id=timtechcorvairwiki:06c_rear_axle:more_on_corvair_axle_ratios&rev=1421329651&do=diff More On Corvair 3.08 Axle Ratio By Tim Palmer and Larry Claypool In last month’s newsletter I mentioned the existence of the 3.08 axle ratio in 1963, but said I didn’t know very much about it. Since then I have received a letter from Larry Claypool with additional information. The 3.08 was introduced as standard equipment on 1963 102hp cars with 4-speed. It wasn’t used with any of the other transmissions, but was available in positraction form at extra cost. For those of you looking for one,… text/html 2015-01-13T22:06:02+00:00 Anonymous (anonymous@undisclosed.example.com) https://www.murfy.us/doku.php?id=timtechcorvairwiki:06c_rear_axle:ratios&rev=1421186762&do=diff Corvair Axle Ratios (Updated) By Tim Palmer, Green Country Corvair Group I have been ask many times what is the standard rear axle ratio for Corvairs. It is complicated. I have went through my Chevrolet Service News and The Corvair Decade to come up with the following chart that should help out. I did not use any sales literature because it is notorious for its errors, besides who believes sales anyway. text/html 2015-01-13T22:06:02+00:00 Anonymous (anonymous@undisclosed.example.com) https://www.murfy.us/doku.php?id=timtechcorvairwiki:06c_rear_axle:start&rev=1421186762&do=diff ~~REDIRECT>timtechcorvairwiki:start~~